set system utilization threshold

Use this command to set the threshold for sending CPU utilization notification messages.

Syntax

set system utilization threshold threshold

Parameters

threshold Specifies a threshold value (in 1/10 of a percent).Valid range is 0–1000. A value of 0 will disable utilization notification messages. Default value: 800 (80%).

Defaults

None.

Mode

All command modes.

Usage

The value range is 0–1000 and represents the percentage of system utilization to use as the trap threshold.

Example

This example shows how to set the system utilization threshold to 90%:

System(rw)->set system utilization threshold 900