show mld flows

Use this command to display MLD flow table entries.

Syntax

show mld flows [port-list port-list] [group group] [vlan-list vlan-list] [sip sip]

Parameters

portlist `portlist`	(Optional) Displays flow table entries by port or range of ports
group `group`	(Optional) Displays flow table entries by multicast group IP address.
vlan-list `vlan-list`	(Optional) Displays flow table entries by VLAN ID or range of VLAN IDs. Valid values are 1 – 4094.
sip `sip`	(Optional) Source IP address. Use 0.0.0.0 to show all sips.

Defaults

If no parameters are specified, information for all MLD flows is displayed.

Mode

All command modes.

Example

System(su)->show mld flows vlan-list 3001 sip 2504::19
 Multicast Flows
--------------------------------------------------------------------------------
Port = ge.1.40
Multicast Group Address = ff04::1:1:1:1
Vlan Id                 = 3001
Source IP Address       = 2504::19
1 entries displayed
System(su)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback