faildetect reset

Use this command to reset an IPv4 or IPv6 SLB real server faildetect configuration to its factory default settings.

Syntax

faildetect reset

Parameters

None.

Defaults

None.

Mode

Configuration command, SLB Real Server Configuration mode.

Usage

The faildetect reset command in a real server configuration context does the following:

Sets the faildetect type to the default value of probe
Sets the probe for faildetect probe one to $slb_default
Removes any configured probe for faildetect probe two

Examples

This example shows how to reset all faildetect configuration to the factory default settings for the 10.1.2.3 port 80 real server on the server farm myproductHTTP:

System(su-config)->ip slb serverfarm myproductHTTP
System(su-config-slb-sfarm)->real 10.1.2.3 port 80
System(su-config-slb-real)->faildetect reset
System(su-config-slb-real)->

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback