Use this command to manually assign Power Sourcing Equipment (PSE) power to a module in the chassis.
| power-value | Specifies a power value in watts. |
| slot-number | Specifies a module slot location for the power assignment. If you are configuring this value on an S-Series SSA, use 1 as the slot number. |
None.
All command modes.
If the total power wattage value set with this command is greater than the maximum power percentage specified with the set inlinepower available command (set inlinepower available), a warning will display. If you execute these parameters, a ratio of assigned power is applied to each module.
This example shows how to assign 200 watts of power to the module in slot 1:
System(rw)->set inlinepower assigned 200 1
Print
this page
Email this topic
Feedback
View PDF
Download EPUB