clear port advertise

Use this command to reset auto-negotiation advertised capabilities to the default setting on one or more ports.

Syntax

clear port advertise port-string [10t | 10tfd | 100tx | 100txfd | 1000x | 1000txfd | 1000t | 1000tfd | pause | apause | spause | bpause]

`port-string`	Specifies port(s) for which advertised ability will be reset.
10t	(Optional) Clears 10BASE-T half duplex mode from the port‘s advertised ability.
10tfd	(Optional) Clears 10BASE-T full duplex mode from the port‘s advertised ability.
100tx	(Optional) Clears 100BASE-TX half duplex mode from the port‘s advertised ability.
100txfd	(Optional) Clears 100BASE-TX full duplex mode from the port‘s advertised ability.
1000x	(Optional) Clears 1000BASE-X, -LX, -SX, -CX half duplex mode from the port‘s advertised ability.
1000xfd	(Optional) Clears 1000BASE-X, -LX, -SX, -CX full duplex mode from the port‘s advertised ability.
1000t	(Optional) Clears 1000BASE-T half duplex mode from the port‘s advertised ability.
1000tfd	(Optional) Clears 1000BASE-T full duplex mode from the port‘s advertised ability.
pause	(Optional) Clears PAUSE for full-duplex links from the port‘s advertised ability.
apause	(Optional) Clears asymmetric PAUSE for full-duplex links from the port‘s advertised ability.
spause	(Optional) Clears symmetric PAUSE for full-duplex links from the port‘s advertised ability.
bpause	(Optional) Clears asymmetric and symmetric PAUSE for full-duplex links from the port‘s advertised ability.

If not specified, all modes of advertised ability will be cleared.

All command modes.

This example shows how to reset all advertised ability to default settings on port ge.3.4:

System(rw)->clear port advertise ge.3.4

Published May 2016prev | next