show chassis compatibility-mode (S-Series)

Use this command to display compatibility mode configuration information and capabilities on an S-Series device.

Syntax

show chassis compatibility-mode [chassis-index chassis-idex] [capabilities]

Parameters

chassis-index `chassis-index`	(Optional) Specifies the chassis index. Valid values are 1 - 2. Default value is 1. A chassis index of 2 can occur in a virtual switch bonding (VSB) context.
capabilities	(Optional) Displays the compatibility mode to which each installed module in the system can be set.

Defaults

The default chassis index is 1.
If capabilities is not specified, compatibility mode settings are displayed.

Mode

All command modes.

Examples

This example displays compatibility settings for a system that is administratively set to auto and is operationally in v1 compatibility mode:

System(rw)->show chassis compatibility-mode
Chassis Index:                             1
Current Fabric Compatibility Admin Mode:   auto

Current Fabric Compatibility Oper Mode: v1

This example displays compatibility settings for a chassis index 2 system that is administratively set to v2 and is operationally in v2 compatibility mode:

System(rw)->set chassis compatibility-mode v2 chassis-index 2
System(rw)->show chassis compatibility-mode chassis-index 2
Chassis Index:                             2
Current Fabric Compatibility Admin Mode:   v2
Current Fabric Compatibility Oper Mode:    v2

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback