show spantree lp

Use this command to display the Loop Protect status per port and/or per SID.

Syntax

show spantree lp [port port-string] [sid sid]

Parameters

port-string (Optional) Specifies port(s) for which to display the Loop Protect feature status. For a detailed description of possible port-string values, refer to Port String Syntax Used in the CLI in the S-, K-, and 7100 Series Configuration Guide.
sid sid (Optional) Specifies the specific Spanning Tree(s) for which to display the Loop Protect feature status. Valid values are 0 - 4094. If not specified, SID 0 is assumed.

Defaults

If no port-string is specified, status is displayed for all ports.

If no SID is specified, SID 0 is assumed.

Mode

All command modes.

Example

This example shows how to display Loop Protect status on ge.2.3:

System(rw)->show spantree lp port ge.2.3
LoopProtect is enabled on port ge.2.3    , SID 0