clear cep

Use this command to clear convergence end points parameters.

Syntax

clear cep {all | policy | detection [detection-id] | users [port-string] | port port-string {all | cisco | lldp-med | h323 | siemens |sip}}

all	Restores factory defaults to all CEP configuration information.
policy	Restore factory defaults to CEP policy configuration.
detection [`detection-id`]	Restore factory defaults to CEP detection group configuration. Optionally, specify a particular CEP configuration group to clear with detection-id. Valid values are 1 - 2147483647.
users [`port-string`]	Clear discovered Convergence Endpoints. Optionally, specify one or more port(s) on which to clear discovered CEPs.
port [`port-string` `{`all \| cisco \|lldp-med \| h323 \| siemens \| sip}]	Resets the CEP enabled state to the default of disabled. Specify one or more port(s) to disable and specify all detection types or individual detection types to disable.

If no detection-id is specified, all CEP detection groups are returned to the default configuration.

If no port-string is specified with the users parameter, all discovered Convergence Endpoints are cleared.

If no port-string is specified with the port parameter, all ports are cleared.

All command modes.

This example shows how to clear all CEP policy parameters

System(rw)->clear cep policy

This example shows how to clear detection id 4 parameters

System(rw)->clear cep detection-id 4

This example shows how to clears ports ge.1.1-5 of Cisco phone detection parameters

System(rw)->clear cep port ge.1.1-5 cisco

Published May 2016prev | next