set cep policy

Use this command to set a global default policy for a CEP detection type.

Syntax

set cep policy {cisco | h323 | lldp-med | siemens | sip} index

Parameters

cisco	Set the Cisco global default policy index.
h323	Set the H323 global default policy index.
lldp-med	Set the LLDP-MED global default policy index.
siemens	Set the Siemens global default policy index.
sip	Set the SIP global default policy index.
`index`	Set the policy index value. This must be configured using the policy management commands described in Policy Profile Commands. Valid values on the S- and K-Series are 0 - 1023. Valid values on the 7100-Series are 0 - 63.

Defaults

None.

Mode

All command modes.

Usage

This is the policy that will be applied when a phone of the specified type is detected on a port. It must be configured using the policy management commands described in Policy Profile Commands.

Example

This example shows how to assign policy index 1 to all H.323 phones detected:

System(rw)->set cep policy h323 1

Published May 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback