Configure the IPFIX Aging Interval

About this task

Use the following procedure to configure an aging interval for IPFIX. The aging interval determines how long a traffic flow that is no longer being received, is retained as a flow.

Procedure

Enter Global Configuration mode:

enable

configure terminal

Example

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Switch:1(config)#ip ipfix aging-interval 30

Variable Definitions

The following table defines parameters for the ip ipfix aging-interval command.


Variable	Value
<1-60>	Specifies (in seconds) the flow record aging interval. The aging interval determines how long a traffic flow that is no longer being received is retained as a flow. The default is 40 seconds.