Configuring IGMP sender entries

Configure IGMP sender entries to identify a source that sends multicast data to a multicast group.

About this task

You can configure IGMP on a VRF instance the same way you configure the Global Router except that you must first launch the appropriate VRF context.

Procedure

  1. In the navigation pane, expand the following folders: Configuration > IP.
  2. Select IGMP.
  3. Select the Sender tab.
  4. Change the appropriate options.
  5. Select Apply.

Sender field descriptions

Use the data in the following table to use the Sender tab.

Name

Description

IfIndex

Specifies the interface where you enabled the IGMP entry.

GrpAddr

Specifies the multicast group address of the multicast stream.

Within the indicated valid range (224.0.0.0 to 239.255.255.255), the following are invalid addresses: 244.0.0.x and the corresponding 31 multicast addresses that map to the IP MAC addresses. If you try to select them, you receive an error message.

MemberAddr

Specifies the IP address of a host.

Action

Flushes an entry or a group.

TPort

Identifies the T port.

State

Indicates whether a sender exists because of an IGMP access filter. The options are filtered and not filtered.

L2Isid

Specifies the Layer 2 I-SID of the C-VLAN.

ScopeIsid

Indicates the scope I-SID of SPB routed multicast sender. If the sender does not support an SPB scope I-SID, the field displays an invalid value of 0xFFFFFFFF.

DataIsid

Indicates the data I-SID of SPB routed multicast sender. If the sender does not support an SPB data I-SID, the field displays an invalid value of 0xFFFFFFFF.