Note
This procedure does not apply to VSP 8600 Series and XA1400 Series.
Perform this procedure to display the Auto-sense configuration on the switch.
Display the Auto-sense configuration related to voice:
Switch:1>show auto-sense voice
===============================================================================
AUTO-SENSE VOICE Config
===============================================================================
TYPE LDDP-AUTH ENABLE I-SID C-VID DSCP PRIORITY
-------------------------------------------------------------------------------
phone FALSE 2000 2000 46 6
-------------------------------------------------------------------------------
1 out of 1 Total Num of AUTO-SENSE entries displayed
-------------------------------------------------------------------------------
Display the Auto-sense status and state on a range of ports:
Switch:1>show interfaces gigabitethernet auto-sense 1/1-1/5
======================================================================
Port Auto-sense
======================================================================
----------------------------------------------------------------------
PORT AUTO-SENSE AUTO-SENSE AUTO-SENSE
NUM STATUS STATE PORT-DATA-ISID
----------------------------------------------------------------------
1/1 Enable UNI-ONBOARDING 500
1/2 Disable OFF
1/3 Disable OFF
1/4 Disable OFF
1/5 Disable OFF
Display the Auto-sense status for Fabric Attach (FA):
Switch:1>show auto-sense fa
==================================================================================
AUTO-SENSE FA Config
==================================================================================
MSG-AUTH MSG-AUTH-KEY
----------------------------------------------------------------------------------
enabled ****
----------------------------------------------------------------------------------
==================================================================================
AUTO-SENSE FA Client specific config
==================================================================================
TYPE EAPOL STATUS I-SID VLANID C-VID MGMT I-SID MGMT C-VID
----------------------------------------------------------------------------------
camera Auto 100 100 untag - -
wap-type1 Auto 200 200 untag - -
open-virtual-switch Auto - - - - -
proxy-no-auth Auth 300 300 untag - -
proxy Auth 400 n/a 400 400 400
----------------------------------------------------------------------------------
6 out of 6 Total Num of AUTO-SENSE entries displayed
----------------------------------------------------------------------------------
Display the Auto-sense wait-interval information.
Switch:1>show auto-sense wait-interval
============================================================================
AUTO-SENSE GLOBAL Config
============================================================================
WAIT
INTERVAL
----------------------------------------------------------------------------
50
----------------------------------------------------------------------------
----------------------------------------------------------------------------
0 out of 0 Total Num of AUTO-SENSE entries displayed
----------------------------------------------------------------------------