View or Modify the Auto-sense Port Configuration

Perform this procedure to view or modify the Auto-sense configuration on one or more ports. You also have the option to disable Auto-sense on the port but retain the configuration that the system applied dynamically. The dynamic configuration becomes a manual configuration and is visible in the show running-config output.

Note

This procedure does not apply to VSP 8600 Series and XA1400 Series.

Procedure

In the navigation pane, expand Configuration > Fabric.
Select AutoSense.
Select the Port AutoSense tab.
To change the Auto-sense state on a port, select a new value for AutoSense in the appropriate row for the port.
Optional: If you disable Auto-sense on a port, select true for AutoSenseKeepAutoConfig to retain the configuration that the system applies dynamically.
Select Apply.

Port AutoSense Field Descriptions

Use the data in the following table to use the Port AutoSense tab.


Name	Description
Index	Displays the index of the port, written in the slot/port[/sub-port] format.
AutoSense	Enables or disables Auto-sense on the specific port. The default value is disabled for existing configurations but enabled for new Zero Touch Fabric Configuration deployments.
AutoSenseKeepAutoConfig	Retains the Auto-sense configuration if you disable Auto-sense on the port. The dynamic configuration becomes a manual configuration and is visible in the show running-config output.
AutoSenseState	Displays the Auto-sense port state.
AutoSenseDataIsid	Specifies the Auto-sense data I-SID per port. The range is 0 to 16777215.