Determine the Protocol Configured on the Added VLAN

Use this procedure to determine the protocol configured on the added VLAN.

The protocol configured on the added VLAN can be one of the following values:

  • snoop

  • snoop-spb

  • route-spb

  • pim

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. Determine the protocol configured on the added VLAN:

    show ip igmp interface [gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}][vlan <1-4059>][vrf WORD<1–16>] [vrfids WORD<0–512>]

    The protocol displays under the Mode column of the command output.

Example

Determine the protocol configured on the added VLAN:

Switch:1#show ip igmp interface

==============================================================================================================
                         Igmp Interface - GlobalRouter
==============================================================================================================
==============================================================================================================
       QUERY              OPER           QUERY   WRONG              LASTMEM                     SCOPE
IF     INTVL STATUS VERS. VERS QUERIER   MAXRSPT QUERY JOINS ROBUST QUERY   MODE       L2ISID   ISID
--------------------------------------------------------------------------------------------------------------
V100   125    activ  2     2   0.0.0.0    100     0     0     2      10      snoop-spb 1100 

1 out of 1 entries displayed

Variable Definitions

The following table defines parameters for the show ip igmp interface command.

Variable

Value

gigabitethernet{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

vlan<1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrfWORD<1–16>

Specifies the VRF instance by the VRF name.

vrfidsWORD<0–512>

Specifies the VRF ID for which to display statistics.